[JDEV] Re: Trouble compiling Jabberd v1.4.2 under recent versions of Cygwin

[Frank Seesink]

	More testing revealed the following:

	./jabberd/jabberd.exe      == works
	./jabberd/jabberd.exe -B   == works
	./jabberd/jabberd.exe -v   == works
	./jabberd/jabberd.exe -Z   == works
	./jabberd/jabberd.exe -D   == BOOM!

I can even use -Z with a whole list of 'zones' (code files)--give or 
take 10-15 at one point--and that's ok.  But the moment I use -D, I get

>>     ____________________________________________________________
>>     Mon Jun 16 20:41:45 2003  mio.c:578 MIO is starting up
>>     Mon Jun 16 20:41:45 2003  mio.c:607 mio while loop top
>>     **Pth** STACK OVERFLOW: thread pid_t=0xa0405c0, name="unknown"
>>     Segmentation fault
>>     ____________________________________________________________

	Does this help at all in figuring out where the issue is?  I have used 
the -Z flag and gone through listing blocks of code files until I've 
covered them all, but I can't get the above error message unless I use -D.

	I have tested this with both a build using the standard distro, and 
then again using my modified Makefile setup and the --enable-ssl flag, 
and the results are the same.  I'm at a loss.