[JDEV] ICQ Transport with Jabber 1.2 - still getting remote s erver error

Eric Bowersox ebowersox at jabber.com
Tue Nov 14 10:33:03 CST 2000


Just a note - the new version of the ICQ transport *will* support the
configuration file mechanism, and we have gotten it to connect to a 1.2
(jabberd) server.  It's not ready for release quite yet though, as there are
some important questions that need to be resolved first.

					Eric

> -----Original Message-----
> From: Dennis Noordsij [mailto:dennis.noordsij at wiral.com]
> Sent: Tuesday, November 14, 2000 3:17 AM
> To: jdev at jabber.org
> Subject: Re: [JDEV] ICQ Transport with Jabber 1.2 - still 
> getting remote
> server error
> 
> 
> On Tuesday 14 November 2000 09:35, you wrote:
> 
> > > huh, where to configure icq to use port 9000? I don't see 
> where in the
> > icq_trans.xml where I can configure this port 9000.
> 
> Quick patch for the icqtransport to connect to port 9000
> 
> 
> Somewhere at the bottom of from_etherx.c you will see the 
> following bit, 
> except the "jabber:component:accept" is called "jabber:server" and 
> "ehandler_new_ex" is simply called "ehandler_new". Also, the 
> "2222" argument 
> to the ehandler_new function is not there.
> 
> {
>   static const char server_namespace[] = "jabber:component:accept";
>   log_debug(ZONE,"[from_etherx_start] kickoff here (host %s, 
> namespace %s)",
> 	    g_config.hostname,server_namespace);
>   g_etherx = ehandler_new_ex(etherx_packet_handler,(char 
> *)(g_config.hostname),
> 			  (char *)server_namespace, 2222);
> 
> } /* end from_etherx_start */
> 
> 
> 
> Then, you change the code to match the above, use 
> jabber:component:accept, 
> use ehandler_new_ex, and add the port you want icqtrans to 
> connect to to the 
> ehandler_new_ex paramaters. In the above example, I am using 
> port 2222, you 
> would use 9000 there.
> 
> When jabberd is running, run icqtrans -D and it should tell you it's 
> connecting to jabberd, if all goes well the last thing it 
> will say (before it 
> waits for activity) is "xmlnode received!"
> 
> MAKE SURE that in icq_trans.xml you connect to the SERVICE 
> JID for the icq 
> transport, not simply localhost or something. Read one of 
> Keith's mails about 
> that.
> 
> The OFFICIAL way to tell the transport which port to connect 
> to is to add a 
> <port>9000</port> section in the icq_trans.xml file, but then 
> you also have 
> to patch the config.c file to understand this and pass it on to 
> ehandler_new_ex. I just hardcoded it because I am lazy :-)
> 
> _______________________________________________
> jdev mailing list
> jdev at jabber.org
> http://mailman.jabber.org/listinfo/jdev
> 




More information about the JDev mailing list